• Mounting the antenna to an outside wall using HUGHES' standard tri-mast roof/wall mounting brackets, or on a rooftop using standard Hughes non-penetrating mount, or a ground pole mount (9 ft. total length). All antennas must be mounted a minimum of 5 ft. off the ground and out of the reasonable reach of small children.


Note: Wall mounts must not be mounted to surfaces or building materials that cannot support the wall mount (for example, stucco, aluminum siding, or vinyl siding).


• Two exterior cable runs or one dual cable run of up to 150 feet of standard RG6 coaxial cable with one point of entry through an exterior wall to an interior wall; and the installation of a wall jack.
• Connecting ground wire from ground block to NEC approved bonding point.
• Installing and weather sealing appropriate cable bushing.
• Conducting a cross-polarization test of the HughesNetTM system to verify receipt of satellite signal on the installer laptop. When possible, the installer should use the customer's PC to confirm receipt of satellite signal.
• Demonstrating to customer that the system is working by surfing the Web and show customer their site ID and signal strength.
• Clean-up of any unnecessary materials from install site.

Non-Standard Installation

• Installations with cable in excess of 150 feet from the HughesNet dish to the HughesNet receiver and/or requiring additional drops or hardware are classified as non-standard installs. Locations that fit this category are typically high-rise buildings and possibly located in cities such as New York, Chicago, San Francisco, etc.
  
  If you have further questions or believe your business may require a non-standard installation, pleasespeak with your HughesNetprofessional installerfor assistance and a quote.